Gas-Fired Products 602-30 Preparing For Installation, Figure, Attaching Mounting Brackets To Wall

in high traffic areas

in windy or drafty areas

IMPORTANT : Vent-free heaters add moisture to the air. Although this is beneficial, installing heater in rooms without enough ventilation may cause mildew formation from too much moisture content. See National Fuel Code for Fresh Air for Combustion and Ventilation.

This appliance may be installed in an aftermarket* manufacture (Mobile) home, where not prohibited by state or local codes.

*Aftermarket : Completion of sale, not for purpose of resale, from the manufacturer.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

CAUTION :

If you install the heater in a home garage:

Heater must be at least 18 inches above floor.

Locate heater where moving vehicle will not hit it.

Preparing For Installation

Select a location for the heater that will provide maximum exposure of the radiant surface to the room, but will not be subjected to accidental contact.

Adequate clearance must be available around the air opening. See Figures 1 & 2 for clearances that must be maintained to the side walls, floor and horizontal surface surrounding the heater.

	CEILING
13"
Minimum	36"
from	Minimum
sides of
heater
Left	Right
side
	side

FLOOR

Minimum to top surface 7" of carpeting. Tile or other combustible material

Figure 1 Figure 2

Attaching Mounting Brackets To Wall

Note: Wall anchors, mounting screws, and spacers are in hardware package. The hardware package is provided with heater

Page 7