anchor or drilled hole.
8. Tighten both screws until heater is firmly secured to wall. Do not over tighten.
Figure 5
1.Clearance requirements from surface of carpeting, tile or other combustible material (See Figure 1.).
Wall Mounted & Floor Mounted With Base Provided
Rear | 0 | Inches |
|
|
| |
Sides | 13 | Inches |
|
|
| |
Top | 36 | Inches |
|
|
| |
Floor | 7 | Inches |
|
|
| |
|
| 18" |
|
| 16" | |
|
|
| Min. |
|
| |
|
|
|
|
|
| |
Adjoining Wall
Floor
1.18"
24"
Min.
30,000 BTU/Hr Model
Figure 6
NOTICE:
Maintain the minimum clearances shown in Figure 1, but you can provide greater clearances from floor, ceiling and adjoining wall.
2.After mounting brackets are installed, hang heater on mounting brackets in holes provided at the rear of heater (See Figure 7.).
Page 9
