3Beginning at the top left inside edge of the bezel, depress the plastic retention tabs toward the outside edge of the bezel, and pull the bezel out from the chassis slightly, enough to keep the tabs from snapping back into place.

Retention tabs

Note: other retention tabs not visible

4Work your way around the bezel until all eight tabs (three left, one bottom, two right, and two top) have been released, then pull the bezel off the chassis.

To install the rack bezel:

1Align the rack bezel with the chassis, just as the tower bezel was aligned prior to removal. Make sure the plastic retention tabs line up with the appropriate slots in the chassis.

2Press the rack bezel onto the chassis until the retention tabs snap into place.

3Align the door with the chassis, just as it was aligned prior to removal.

4Insert the hinge pins (2) into the hinge-pin sockets, allowing the door to fall into place, then close the door.

Converting to rackmount

5