Setting up and synchronizing the wireless keyboard and mouse
Before using the wireless mouse and keyboard, install the batteries into both devices, connect the power adapter to the mouse charging cradle, charge the mouse for 9 hours before using, and synchronize the mouse and keyboard with the radio frequency (RF) receiver on your Family Media Center.
3 Connect the power adapter to the mouse charging cradle, then plug the power adapter into the power outlet.
To install and charge the mouse battery pack
1 Press the battery release button on the end of the mouse, then remove the battery pack and discard the plastic insulator tab.
2 Insert the battery pack back into the battery compartment.
4 Place the mouse in the charging cradle. The cradle’s LED indicator light,
located at the bottom of the cradle, turns solid green and the mouse LED indicator will faintly flash green while the batteries are charging.
The mouse LED indicator lights
continuously when it is fully charged and ready to use.
Tip:
To conserve power, the mouse enters a “sleep mode” when it is left on and not used for more than 24 hours. Click any mouse button to wake the mouse from “sleep mode.”
Tip:
Tip:
8
When the battery drops to 20% of its full charge, the mouse LED indicator blinks intermittently while in use. To optimize the NiMH battery, recharge it at the end of each day’s use.
If you do not need a fully charged battery for extended use, you can remove the mouse from the charging cradle at anytime. You do not need to wait for the mouse’s LED indicator light to stop flashing.