Chapter 4: Maintenance and Troubleshooting

The display image does not cover the entire screen

■If you are using RGB mode, make sure that H-WIDTH and V-SIZE in the OSD are set correctly.

■If you are using TV, AV1, AV2, or component with 480i input, use the SCREEN WIDTH or WIDE button on the remote control to scroll through various screen modes.

You can see a picture but you cannot hear sound

■Make sure that the volume is not turned down.

■Make sure that the sound is not muted.

■Make sure that your audio input source cables are connected securely and correctly.

The monitor has pixels that are always dark

■Your plasma TV is manufactured using an extremely high level of precision technology. However, sometimes some pixels of your plasma TV may not display. Pixel defects within industry specifications are inherent to this type of product and do not constitute a defective product.

An image remains on the screen even after you turn off your plasma TV

■A still image may have been displayed for an extended period of time causing burn-in. For more information about burn-in, see page 41.

You see “noise” or “trash” on the screen

■When your plasma TV’s digital capabilities exceed a digital broadcast signal, the signal is up-converted (increased) to match your plasma TV’s display capabilities. Up-converting can cause noise or trash.

Screen brightness is diminished

■Video display devices experience degradation of brightness over the life of the device. Normal brightness degradation is not covered by your warranty.

46

www.gateway.com