GBC 930-115 manual Setting up your laminator, Paper Guide

Polaris II	Operations Manual
4.2 Setting up your laminator	Figure 4.2.1 Paper Guide

After placing your Polaris laminator, the catch table must be installed.

1.To assist in the installation of the catch table, a set of tools has been provided. The tools are sent with the machine and can be found wrapped up on the front feed table.

2.Locate rear feed table and inspect for any damages that may have been caused during shipping. Locate Four bolts, two C-clamps, two flat mounting plates, two legs, and four nuts.

3.Place the table leg between the C-clamp and the flat mounting plate. Secure the legs to the table using bolts and nuts. NOTE: These legs may have been pre- assembled at the factory.

4.At this time the feed table legs can be adjusted to desired height (approx 16”). Table height (angle) depends on the paper stock being laminated. Tighten nuts.

5.After the feed table is set to desired height, mount the table on the machine using the front table hooks. To apply the rear catch table, first locate the catch table support bar located at the rear of the machine. The catch table hooks directly to the catch table support bar

6.At this time the paper guides can be mounted onto the catch table. See Figure 4.2.1.

P A P E R G U I D E

C A T C H T A B L E

Once the catch table is in place, connect the air/ vaccum pump (rated 230V@ 10 Amps or less) to the receptacle located under the separator. The receptacal is identified by the label shown below.

Refer to Section 3.5 Electrical requirements

Page 4-2 © 2004 General Binding Corporation