GBC Laminator manual Maintenance and Troubleshooting, F-60 Operation and Maintenance Manual

Maintenance and Troubleshooting F-60 Operation and Maintenance Manual

To clean beads of adhesive, dust and dirt from the rolls:

1.Allow the laminator to cool slightly to no higher than 110ºF (43ºC).

2.Set the FWD/REV switch to the REV position.

3.Clean the rolls using a moderate amount of 80% isopropyl alcohol on a cotton terry cloth.

CAUTION

Use the minimum amount of pressure necessary to clean the rolls. You can destroy the silicone layer on the rolls by pressing to hard or scrubbing too long in one spot.

WARNING

Exercise care when cleaning the rolls with 80%

isopropyl alcohol:

•Use only in a well ventilated area.

•Wear rubber gloves.

•Use only on cool rolls.

Cleaning heated rolls can ignite the fumes.

CAUTION

Use only 80% isopropyl alcohol or a rubber cement eraser to clean the laminating rolls.

Harsh chemicals like toluene, acetone or MEK

destroy the silicone covering of the rolls.

4.With the laminator rolls no hotter than 110ºF, remove dust and dirt from the silicone laminating rolls by running an adhesive-coated board through the laminator. Be sure to set the nip for the thick- ness of the board used.

5.Allow the laminator to cool.

To clean the cabinet and covers:

WARNING

Remove and lockout power from the laminator while you are performing this procedure. You could be severely shocked, electrocuted, or get your fingers caught in the drive mechanisms.

1.Using a damp cotton terry cloth (water only), clean the exterior of the laminator.

WARNING

Do not use liquid or aerosol cleaners on the

laminator. Do not spill liquid of any kind on the

laminator. You can be severely shocked,

electrocuted or cause a fire. Use only a damp

cloth for cleaning.

4-2 © GBC Pro-Tech 1998 July