Section 4 - Confirming the installation of RAM
These steps confirm that the printer recognizes the additional memory:
1.Switch on the printer.
2.Press the On Line button on the control panel; you’ll see the message “Off Line” in the display panel.
3.Press the Menu key four times; “Printer Info” appears in the display panel.
4.Press the Enter key; you’ll see the total amount of RAM that the printer recognizes. If this is the same as the new total of RAM, press the On Line key and the printer goes back on line.
If this figure is not the same as the total amount of RAM, turn the printer off, and remove the side cover. Repeat from step 14 (Elite 12) or step 11 (Elite XL 20) in the previous steps, starting from “If the ready message doesn’t appear . . .”
Updating LaserWriter 8 printer driver (Macintosh Only)
After extra memory is installed, the LaserWriter 8 driver configuration must be updated on every Macintosh that uses the printer.
1.Switch the printer on.
2.Select the Chooser from the Apple ( ) menu.
3.Click the LaserWriter 8 icon in the upper left area of the Chooser. You’ll see the name of your printer in the upper right area of the Chooser below “Select
a PostScript printer.” If the name is not highlighted, click on it to highlight it.
4.Click on the Setup button. You’ll see the Setup dialog box.
5.Click on the Auto Setup button. You’ll see a message box telling you that the computer is communicating with the printer.
6.After a few seconds you’ll see the Setup dialog box again. Click the OK button to return to the Chooser, and then close the Chooser.
7.Repeat the preceding six steps on every Macintosh that will use the printer.
12
