3 INSTALLATION NOTE !
Strictly observe the ‘UPS Safety Rules’.
Read carefully the UPS ‘Operating Manual & Installation
Guide’ before installing or operating the equipment.
If any problems are encountered with the installation
procedure here described, please contact the nearest
Service Centre before proceeding.
3.1 3-PH SNMP/WEB PLUG-IN ADAPTER (P/N 1018959)
NOTE ! SitePro customers only
SitePro units produced before 2003 require an additional
protective ground connection – refer to APPENDIX A.
3.1.1 Setting the logical address
The logical address is configured through dip-switch SW1 in the following way:
Logical Address Dip 1 Dip 2
SNMP Card 0 (1) 84 (54h) ON ON
SNMP Card 1 85 (55h) ON OFF
SNMP Card 2 86 (56h) OFF ON
SNMP Card 3 87 (57h) OFF OFF
(1) Default setup
Dip-switch SW1
NOTE: The logical address is a critical setting when more than one SNMP Card is installed in the same
UPS system.
Modifications reserved Page 14/24
ISG_CNT_SNM_BAS_CRD_1GB_V012.doc Installation Guide SNMP/Web Adapter