Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information
Installing the water line.
Read these instructions completely and carefully.
What You Will Need
To determine how much copper tubing you need:
Measure the distance from the water valve on the back of the refrigerator to the water supply pipe. Then add 8 feet (244 cm). Be sure there is sufficient extra tubing [about 8 feet (244 cm) coiled into 3 turns of about 10 inches (25 cm) diameter] to allow the refrigerator to move out from the wall after installation.
■A water supply kit (containing copper tubing, shutoff valve and fittings listed below) is available at extra cost from your dealer or from Parts and Accessories,
■A cold water supply. The water pressure must be between 20 and 120 p.s.i.
■Power drill.
■Copper tubing, 1/4″ outer diameter to connect the refrigerator to the water supply. Be sure both ends of the tubing are cut square.
Do not use plastic tubing or plastic fittings because the water supply line is under pressure at all times. Certain types of plastic tubing may become brittle with age and crack, resulting in water leakage.
■Two 1/4″ outer diameter compression nuts and 2 ferrules (sleeves)— to connect the copper tubing to the shutoff valve and the refrigerator water valve.
■If your existing water line has a flared fitting at the end, you will need an adapter (available at plumbing supply stores) to connect the water line to the refrigerator OR you can cut off the flared fitting with a tube cutter and then use a compression fitting.
■Shutoff valve to connect to the cold water line. The shutoff valve
should have a water inlet with a minimum inside diameter of 5/32″ at the point of connection to the COLD WATER LINE.
26
