About the automatic icemaker. | GEAppliances.com |
A |
|
|
|
Icemaker Accessory Kit |
|
If your refrigerator did not come already | models, or |
equipped with an automatic icemaker, | available at extra cost. |
an icemaker accessory kit |
|
Safety Instructions
Mounting Block | Screws |
Part No. WR2M3604 | Part No. WR1M478 |
Icemaker Installation
A special icemaker mounting block must be used when installing an icemaker. Directions on how to install the icemaker mounting block are included in the Icemaker Accessory Kit Installation Instructions.
For U.S. models, the mounting block is included with the refrigerator. For Canadian models, the mounting block is included in the optional icemaker accessory kit
Operating Instructions
Power Switch |
| Automatic Icemaker (on some models) |
|
| Icemaker |
|
| The icemaker will produce seven cubes |
|
| per |
|
| in a |
|
| freezer compartment temperature, |
|
| room temperature, number of door |
|
| openings and other use conditions. |
| Feeler Arm | If the refrigerator is operated before the |
| water connection is made to the icemaker, | |
|
| |
|
| set the power switch to O (off). |
|
| When the refrigerator has been connected |
|
| to the water supply, set the power switch to |
|
| I (on). Do not open the door/drawer for |
|
| approximately 4 hours. This will allow the |
|
| freezer to reach the correct operating |
|
| temperature for making ice, and will |
|
| prevent water from spilling out of the |
|
| icemaker mold. |
|
| Special Note about the Green Power Light: |
|
| Even when the icemaker power switch is in |
|
| the I (on) position, power to the icemaker |
|
| will be interrupted when the freezer |
|
| door/drawer is open. This prevents ice |
|
| ejecting from the icemaker from missing |
|
| the ice bucket and dropping into the back |
|
| of the freezer. Because power to the |
|
| icemaker is interrupted while the |
|
| door/drawer is open, the green power light |
|
| on the icemaker will be off. To make sure |
|
| the icemaker is working properly, press the |
|
| freezer light switch located on the upper |
|
| right side of the freezer compartment. The |
|
| power light on the icemaker will come on. |
The icemaker will fill with water when it cools to 15°F
Throw away the first few batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker, set the power switch to O (off) and remove the cubes. Set the power switch to I (on) to restart the icemaker.
After the icemaker has been turned on again, there will be a delay of about
45 minutes before the icemaker resumes operations.
NOTE: In homes with
Installation Instructions Troubleshooting Tips Consumer Support
9