GE 197D7799P001 operating instructions RE-HANGING the Doors, Reversing the Door Handles

Center Hinge Pin

Installation Instructions

2REVERSING THE DOOR SWING (CONT.)

5REVERSING THE DOOR HANDLES (CONT.)

5.4 Transfer Freezer Door Handle

5.4.1	Remove the screw	TopOP
	holding the handle
	to the top of the
	door and the two
	screws holding the
	handle to the bottom
	of the door.
5.4.2	Remove the handle.

Bottom

5.4.3Remove the screw from the

right top edge of the door and insert it into the handle screw hole on the left side.

5.4.4Transfer the door stop as shown in preceding section 5.2.

5.4.5 Attach the handle to the right edge of the door with screws at top and bottom, using bottom holes vacated by removal of the door stop screws.

6RE-HANGING THE DOORS

6.1 Re-hang the fresh food door

6.1.1Lower the fresh food door onto the bottom hinge pin. Be sure the washer is in place on the pin.

Plastic

Washer

Hinge

Bracket

6RE-HANGING THE DOORS (CONT.)

6.1.2Insert the pin on the center hinge into the socket in the top of the door. Place the spacer, then the

washer, on the hinge pin.	Hinge Pin
NOTE: The center hinge must
be turned over as shown when
mounted on the left side.
	Plastic Washer
	and Spacer

6.1.3Tilt the door toward the cabinet. As the door is brought into position, slide the hinge under the head of the screw which earlier had been partly driven into the outermost hole. Insert the remaining screw, then tighten both screws securely.

6.2 Re-hang the freezer door

6.2.1 Lower the freezer door onto the center hinge pin. Be sure the washer and spacer are in place on the pin.

Plastic Washer

and Spacer

6.2.2Tilt the door toward the cabinet, lifting the top hinge so the pin fits into the socket on the top of the door.

6.2.3.Make sure the door is slightly above the top of the cabinet and the gap between the doors is even across the front. Tighten the top hinge screws. Do not overtighten these screws–tighten them until they are just snug, then turn them another one-half turn.

16