About storage drawer and cover removal. | ge.com |
Not all features are on all models.
Adjustable Humidity Drawer (on some models)
Slide the control all the way to the | Slide the control all the way to the LOW |
HIGH setting to provide high humidity | setting to provide lower humidity levels |
recommended for most vegetables. | recommended for most fruits. |
Drawer and Cover Removal
Drawers can be removed easily by grasping the sides and lifting up slightly while pulling drawers past the stop location.
Plastic Cover
To remove the cover, lift it off its supports, pull it forward, tilt it and take it out.
Safety Instructions Operating
Twin Drawer Shelf
To remove:
1 Remove the drawers.
2 Reach in, push the front of glass cover up, and at the same time, pull it forward as far as it will come.
Tilt it and take it out. Avoid cleaning the cold glass cover with hot water because the extreme temperature difference may cause it to break.
3 Remove the drawer frame. (Always remove the glass cover before you take out the drawer frame.)
Lift the frame off the supports at each side and back, pull it forward, tilt it and take it out.
To replace:
1 Lower the frame until it rests on the supports at each side and back.
2 Replace the glass cover, pushing its rear edge firmly into the rear frame channel and gently lowering the front into place.
3 Replace the drawers.
Instructions Installation Instructions
About the automatic icemaker.
A
There are 2 types of icemakers:
Power Switch | Icemaker |
|
Green Power Light | Feeler Arm |
Power switch model
Feeler Arm in the STOP
Feeler Arm in (up) position the ON (down)
position
Feeler arm model
Automatic Icemaker (on some models)
The icemaker will produce approximately
If the refrigerator is operated before the water connection is made to the icemaker, move the feeler arm to the STOP (up) position.
When the refrigerator has been connected to the water supply, move the feeler arm to the ON (down) position.
The icemaker will fill with water when it cools to 15°F. A
Once the icemaker starts to make ice,
it may take up to 48 hours to fill the bin, depending on the temperature settings and number of door openings.
You will hear a buzzing sound each time the icemaker fills with water.
Throw away the first few batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become cloudy, taste stale, shrink or fuse together.
On power switch models, the green power light will blink if ice cubes get stuck in the icemaker. To correct this, set the power switch to O (off) and remove the cubes. Set the power switch to I (on) to restart the icemaker. After the icemaker has been turned on again, there will be a delay of about 45 minutes before the icemaker resumes operation.
NOTE: In homes with
Icemaker Accessory Kit
If your refrigerator did not already come equipped with an automatic icemaker, an icemaker accessory kit is available at extra cost.
Check the back of the refrigerator for
the specific icemaker kit needed for 7 your model.
