Dishwasher Installation
•Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher.
4" | 5" | 5" | 4" |
|
| 4" |
|
6"6"
Water House 
Line Wiring
Figure M
STEP 9: INSTALL DRAIN HOSE,THROUGH CABINET•Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate hole.
Maximum Drain Hose
Length 10'
Insulation
Blanket
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
Figure N
Tip: Prevent unnecessary service call charges for no fill, drain or noise concerns.
Position utility lines so they do not interfere with anything under or behind the dishwasher.
IMPORTANT – Do not push against front panel with knees. Damage will occur.
•Grasp the sides of the front panel and slide dishwasher into the opening a few inches at a time.
Do not push against front door panel with
Figure O knee. Damage to the door panel will occur.
•As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher extends about 6 inches forward of adjacent cabinets.
•Make sure drain hose is not kinked under or behind the dishwasher.
•Make certain the house wiring, drain line and water line do not interfere with components under dishwasher.
STEP 11: INSTALL TRIM PIECES (some models)
Skip this step if trim is not supplied with the dishwasher. In this step you will need the trim pieces set aside in Step 1.
•Position the trim pieces so the lips face toward the dishwasher door.
•Select a long trim piece and press it onto the left side tub flange. Start with the top edge and press the trim piece completely onto the tub flange as you move towards the bottom. Repeat for the right side tub flange trim piece.
•Install remaining trim piece on the top tub flange.
CaX\BcaX_
CaX\
BcaX_
CaX\ 
BcaX_C^_EXTf
Figure P
8