GE 20 manuel dutilisation Performance Data Sheet, Operating Specifications, Special Notices

Models: 20

1 64
Download 64 pages 24.92 Kb
Page 19
Image 19
Performance Data Sheet

Performance Data Sheet

SmartWater Filtration System

MWF Cartridge

This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below.

The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/53.* (100% safety factors built in for unmetered usage)

Standard No. 42: Aesthetic Effects

Parameter

USEPA

Influent

Influent

Effluent

% Reduction

Min. Required

 

MCL

Challenge Concentration

Average

Average

Maximum

Average

Minimum

Reduction

Chlorine

2.0 mg/L + 10%

1.96 mg/L

0.06 mg/L

0.11 mg/L

96.77%

94.74%

> 50%

T & O

Particulate**

≥ 10,000 particles/mL

6,400,000 #/mL

58,833 #/mL

150,000 #/mL

99.14%

97.97%

≥ 85%

Standard No. 53: Health Effects

Parameter

USEPA

Influent

Influent

 

 

 

 

 

Effluent

% Reduction

Min. Required

 

 

MCL

Challenge Concentration

Average

 

 

Average

Maximum

Average

Minimum

 

Reduction

Turbidity

0.5 NTU

11 + 1 NTU***

10.5 NTU

 

 

0.14 NTU

0.28 NTU

98.54%

97.20%

 

0.5 NTU

Cysts

≥ 99.95% Reduction

Minimum 50,000 L

118,750 #/L

 

 

 

< 1 #/L

4 #/L

> 99.99%

> 99.99%

 

≥ 99.95%

Asbestos

≥ 99% Reduction

107 to 108 fibers/L; > 10µm

57 MF/L

 

 

0.996 MF/L

< 1 MF/L

99.60%

99.39%

 

≥ 99%

Lead at pH 6.5

0.015 mg/L

0.15 mg/L + 10%

0.1567 mg/L

 

 

< 0.001 mg/L

< 0.001 mg/L

99.36%

99.29%

 

0.010 mg/L

Lead at pH 8.5

0.015 mg/L

0.15 mg/L + 10%

0.1433 mg/L

 

 

< 0.001 mg/L

< 0.001 mg/L

99.30%

99.29%

 

0.010 mg/L

Mercury at pH 6.5

0.002 mg/L

0.006 mg/L + 10%

0.0059 mg/L

 

0.000350 mg/L

0.0007 mg/L

94.70%

87.50%

 

0.002 mg/L

Mercury at pH 8.5

0.002 mg/L

0.006 mg/L + 10%

0.0057 mg/L

 

0.000325 mg/L

0.0006 mg/L

93.20%

89.29%

 

0.002 mg/L

Alachlor

0.002 mg/L

0.04 mg/L + 10%

0.0367 mg/L

 

 

0.00023 mg/L

0.0004 mg/L

99.34%

98.67%

 

0.002 mg/L

Lindane

0.0002 mg/L

0.002 mg/L + 10%

0.0020 mg/L

 

< 0.00002 mg/L

< 0.00002 mg/L

99.00%

98.95%

 

0.0002 mg/L

2,4-D

0.070 mg/L

0.210 mg/L + 10%

0.2033 mg/L

 

 

0.00337 mg/L

0.011000 mg/L

98.32%

94.50%

 

0.070 mg/L

Toxaphene

0.003 mg/L

0.015 mg/L + 10%

0.0160 mg/L

 

 

0.00100 mg/L

0.001000 mg/L

93.44%

91.67%

 

0.003 mg/L

Benzene

0.005 mg/L

0.015 mg/L + 10%

0.0145 mg/L

 

0.000500 mg/L

0.000500 mg/L

96.51%

95.83%

 

0.005 mg/L

Carbofuran

0.040 mg/L

0.080 mg/L + 10%

0.0830 mg/L

 

0.001000 mg/L

0.001000 mg/L

98.78%

98.65%

 

0.04 mg/L

1,4 dichlorobenzene

0.075 mg/L

0.225 mg/L + 10%

0.2283 mg/L

 

0.000500 mg/L

0.000500 mg/L

99.78%

99.77%

 

0.075 mg/L

Atrazine

0.003 mg/L

0.009 mg/L + 10%

0.0087 mg/L

 

 

< 0.0005 mg/L

< 0.0005 mg/L

94.22%

93.33%

 

0.003 mg/L

* Tested using a flow rate of 0.50 gpm; pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 68° ± 5°F (20° ± 3°C)

 

 

 

 

** Measurement in Particles/ml. Particles used were 0.5-1 microns

 

 

 

 

 

 

 

 

 

 

 

 

*** NTU=Nephelometric Turbidity units

 

 

 

 

 

 

 

 

 

State of California

 

 

Operating Specifications

 

 

 

 

 

 

 

 

 

Department of Health Services

 

 

 

 

 

 

 

 

 

 

 

Water Treatment Device

 

 

￿ Capacity: certified for up to 300 gallons (1135 l); up to six

 

 

 

 

 

 

Certificate Number

 

 

 

months for models without a replacement filter indicator light;

 

 

 

 

 

 

05 - 1698

 

 

 

up to one year for models with a replacement filter indicator light

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

￿ Pressure requirement: 40–120 psi (2.8–8.2 bar), non-shock

 

 

 

 

 

 

Date Issued: February 2, 2005

 

 

￿ Temperature: 33–100ºF (0.6–38ºC)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

￿ Flow rate: 0.5 gpm (1.9 lpm)

 

 

 

 

 

 

 

Trademark/Model Designation

 

Replacement Elements

General Installation/Operation/Maintenance Requirements

 

 

 

 

MWF

 

 

MWF

 

 

 

 

 

 

Manufacturer: General Electric Company

 

 

 

￿ Flush new cartridge at full flow for 3 minutes to purge out

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

trapped air.

 

 

 

 

 

 

 

 

 

The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section

￿ Replace cartridge when the indicator light flashes or water

 

 

 

 

116830 of the Health and Safety Code for the following health related contaminants:

 

 

 

 

 

 

 

 

 

 

 

 

flow rate is reduced on non-indicator units.

 

 

 

 

 

 

Microbiological Contaminants and Turbidity

Inorganic/Radiological Contaminants

Special Notices

 

 

 

 

 

 

 

Cysts

 

 

Asbestos

 

 

 

 

 

 

 

 

 

Turbidity

 

 

Lead

 

 

￿ Installation instructions, parts and service availability, and standard

 

 

 

 

 

 

 

Mercury

 

 

 

warranty are included with the product when shipped.

 

 

 

 

 

 

Organic Contaminants

 

 

 

 

￿ This drinking water system must be maintained according to

 

 

 

 

Alachlor

 

 

 

 

 

 

 

 

 

Atrazine

 

 

 

 

 

 

manufacturer’s instructions, including replacement of filter cartridges.

 

 

Benzene

 

 

 

 

 

￿ Do not use with water that is microbiologically unsafe or of unknown

 

 

 

 

Carbofuran

 

 

 

 

 

 

 

 

Lindane

 

 

 

 

 

 

quality without adequate disinfection before or after the system.

 

 

 

 

Mercury

 

 

 

 

 

 

Systems certified for cyst reduction may be used on disinfected water

 

 

 

 

Toxaphene

 

 

 

 

 

that may contain filterable cysts.

 

 

 

 

 

 

 

1,4-dichlorobenzene

 

 

 

 

 

 

 

 

 

 

 

 

2,4-D

 

 

 

 

 

￿ The contaminants or other substances removed or reduced by this

 

 

 

 

 

 

 

 

 

water treatment system are not necessarily in your water.

 

 

 

 

 

 

 

 

 

 

￿ Check for compliance with the state and local laws and regulations.

 

 

 

 

 

 

 

 

￿ Note that while the testing was performed under standard laboratory

 

 

 

 

 

 

 

 

 

 

 

conditions, actual performance may vary. Systems must be installed and

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

operated in accordance with manufacturer’s recommended procedures

 

 

Rated Service Capacity: 300 gal

 

Rated Service Flow:

0.5 gpm

 

and guidelines.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Do not use where water is microbiologically unsafe or with water of unknown quality, except that systems certified for

 

 

 

 

 

 

 

 

 

 

 

 

 

Conditions of Certification:

 

 

 

 

 

 

 

 

 

 

 

 

 

cyst reduction may be used on disinfected waters that may contain filterable cysts.

 

 

 

System Tested and Certified by NSF International against

 

 

 

 

 

 

 

 

 

 

 

 

 

ANSI/NSF Standard 42 & 53 for the reduction of:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Standard No. 42: Aesthetic Effects

 

Standard No. 53: Health Effects

 

 

 

 

 

 

 

 

 

 

 

Chemical Unit

 

 

Chemical Reduction Unit

 

 

 

 

 

 

 

 

 

 

 

 

 

Chlorine Taste and Odor

 

Alachlor and Atrazine Reduction

 

 

 

 

 

 

 

 

 

 

 

Mechanical Filtration Unit

 

Benzene and Carbofuran Reduction

 

 

 

 

 

 

 

 

 

 

 

 

1,4 dichlorobenzene and 2,4-D Reduction

 

 

NSF®

 

 

 

 

 

 

Particulate Reduction, Class I

 

 

 

 

 

 

 

 

 

 

Lead and Lindane Reduction

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Mercury and Toxaphene Reduction

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Mechanical Filtration Unit

 

 

 

 

 

 

 

 

 

 

 

19

 

 

 

 

Turbidity Reduction

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Cyst and Asbestos Reduction

 

 

Manufactured for: General Electric Company, Louisville, KY 40225

 

 

 

 

 

 

EPA EST. No. 070595-MN-001

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 19
Image 19
GE 20 manuel dutilisation Performance Data Sheet, Operating Specifications, Special Notices