Step-by-step installation instructions.
Faucet Installation
Be sure there is room underneath the sink to make the needed connections. Select one of the following places to install the faucet:
NOTE: Looking at second illustration at right, be sure the faucet base will fit flat against the surface at the selected location so the gasket will seal.
1 If drilling is needed, make a 3⁄4 ″ dia. hole. Be sure to use the proper procedure for drilling porcelain or stainless steel. Special drill bits may be needed.
2 | Place small gasket, base and large gasket (in that order) onto the | |
faucet stem. Next, place lock washer and hex nut onto faucet stud. | ||
| ||
| Insert tubing insert into tubing adapter. Securely tighten to faucet stud. | |
3 | ||
| Feed the length of 3⁄8 ″ OD tube from the bottom, up through the | |
4 | ||
mounting hole. Connect to the tubing adapter as shown in second | ||
|
illustration, tightening the compression nut securely.
Spout
Lever
Faucet
Faucet stud
ASSEMBLED
Small gasket 
Base
Large gasket
5
6
Remove the short shipping tube and insert the spout into the faucet body. Rotate spout into place.
Lower the faucet assembly into place on the underside of the mounting hole. Place the mounting bracket above the lock washer. While holding the mounting bracket in place, securely tighten the hex nut.
Sink 
Mounting bracket
Lock washer 
Hex nut
Tubing insert
Tubing adapter
Compression nut
Tubing adapter |
Tubing insert |
Compression nut |
3/8″ tubing, (run to Filter outlet)
6
