Intercom Operation
(applicable only with additional handsets)
The intercom feature allows you to have a conversation with another registered handset without tying up the telephone line, allowing you to still receive incoming calls.
Making an Auto Intercom Call
1.Make sure the handset is OFF (not in TALK mode).
2.Press the delete/int/conf button on the handset.
3.Use the
NOTE:
a)If the user has not entered the paged handset number within a few seconds, the handset shall display a paged handset number list (i.e. Handset 2, Handset 3, Handset 4, Handset 5 and Handset 6) if Handset 1 is paging the handset.
b)Even if the handset has not been registered with all 6 handsets, the paging list will display all handset numbers.
c)If the user has selected a paged handset number that has not been registered, the handset will emit an error tone and ask the user to retry again.
4.A long beep is heard and then the two handsets are immediately connected. Receiving handset shall immediately come into the auto intercom mode that both “microphone” and “speaker” of this receiving handset shall be enabled such that the user of receiving handset can freely talk and listen to the conversation.
5.When finished, press the END button or delete/int/conf button on either handset to deactivate the intercom.
NOTE: The system is expandable up to 6 handsets (by purchase of optional Model 28203 handset with recharge cradle). When 4 handsets are registered, the system can handle 2 separate intercom operations at once, for example, 1st handset intercoms with 2nd handset while 3rd handset intercoms with 4th handset.
27
