GE 200D8074P009, 49-60456 About the ice and water dispenser. on some models, To Use the Dispenser

About the ice and water dispenser. (on some models) ge.com

Safety

To Use the Dispenser

Select CUBED ICE, CRUSHED ICE or WATER.

Press the glass gently against the top of the dispenser cradle.

The spill shelf is not self-draining. To reduce water spotting, the shelf and its grille should be cleaned regularly.

	If no water is dispensed when the refrigerator is first
	installed, there may be air in the water line system. Press
	the dispenser arm for at least two minutes to remove
	trapped air from the water line and to fill the water
	system. To flush out impurities in the water line, throw
Spill Shelf	away the first six glassfuls of water.
	CAUTION: Never put fingers or any other objects into the
	ice crusher discharge opening.

Locking the Dispenser

Press the LOCK pad for 3 seconds to lock the dispenser and control panel. To unlock, press and hold the pad again for 3 seconds.

Dispenser Light

The LIGHT pad turns the night light in the dispenser on and off. The light also comes on when the dispenser cradle is pressed. On some models, if this light burns out, it should be replaced with a 6 watt 12V maximum bulb.

Quick Ice

When you need ice in a hurry, press the QUICK ICE pad to speed up ice production. This will increase ice production for the following 48 hours or until you press the pad again.

Door Alarm

To set the alarm, press the DOOR ALARM pad until the indicator light comes on. This alarm will sound if either door is open for more than 3 minutes. The light goes out and the beeping stops when you close the door.

Instructions Operating Instructions

Precise Fill

This water dispenser is equipped with a feature called “precise fill.” This feature allows you to choose a precise amount of water (cups or ounces) that you would like dispensed.

Press the WATER pad.

Press the CUPS or OUNCES pad.

Select the precise amount of water you would like dispensed.

If you selected OUNCES, press the arrow pads on either side of the display to select the number of ounces you would like to have dispensed between 1–99 ounces.

If you selected CUPS, press the arrow pads on the left of the display to select the whole cups (1–16 cups) and/or the arrow pads on the right side of the display to select fractions of a cup (1/4–3/4 cups).

Press the cup against the cradle and water will begin dispensing. It will automatically stop when the amount set has been dispensed. The display will show there

is no water left to dispense, then reset.

NOTE: Do not leave the dispenser unattended when water is being dispensed.

If you would like to stop dispensing water before the specified amount has been dispensed, just remove the cup from the cradle. The display will show the amount left to dispense.

Installation Instructions Troubleshooting

Important Facts About Your Dispenser

Tips

■Do not add ice from trays or bags to the storage drawer. It may not crush or dispense well.

■Avoid overfilling glass with ice and use of narrow glasses. Backed-up ice can jam the chute or cause the door in the chute to freeze shut. If ice is blocking the chute, poke it through with a wooden spoon.

■Beverages and foods should not be quick- chilled in the ice storage drawer. Cans, bottles or food packages in the storage drawer may cause the icemaker or auger to jam.

■To keep dispensed ice from missing the glass, put the glass close to, but not touching, the dispenser opening.

■Some crushed ice may be dispensed even though you selected CUBED ICE. This happens occasionally when a few cubes accidentally get directed to the crusher.

■After crushed ice is dispensed, some water may drip from the chute.

■Sometimes a small mound of snow will form on the door in the ice chute. This condition is normal and usually occurs when you have dispensed crushed ice repeatedly. The snow will eventually evaporate.

15

Consumer Support