Installation Instructions
3ELECTRICAL CONNECTIONS (cont.)
When disconnecting the power cord from the adapter, always hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use. Should this happen, DO NOT USE the appliance until a proper ground has again been established.
BUsage Situations where Appliance Power Cord will be Disconnected Frequently.
Do not use an adapter plug in these situations because disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal. The customer should have the
The installation of appliances designed for mobile home installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard for Manufactured Home Installations, latest edition (Manufactured Home Sites, Communities and
Electric Disconnect
•Locate disconnect plug on the range back.
•Pinch sides of connector and pull out of range back.
4SEALTHE OPENINGS
Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.
5LIGHTTHE PILOTS
(For models equipped with standing pilots. If the range is an electric ignition model, the burners are ignited by electric ignition which eliminates the need for standing pilot lights.)
The range should be installed in its permanent position before any pilots are lit or adjusted.
CAUTION — Make sure the surface burner control knobs are in the OFF position before attempting to light the pilots.
ALight the Surface Burner Pilots
1.Raise the cooktop.
2.Light both pilots with a match.
3.To avoid pilot outage, use caution when closing cooktop after lighting pilots.
5/16″
NOTE: Do not leave standing pilot lit in a newly constructed or remodeled home or apartment that will be unoccupied for more than a month.
Each pilot flame was adjusted at the factory to be approximately 5/16″ tall.
A tinge of yellow appearing at the upper tip is normal. If you find pilot adjustment is necessary, follow instructions in Step B.
34
