Installation Instructions
6LEVELTHE RANGE
AInstall the oven racks in the oven
and position the range where it will be installed.
|
| Raise | Lower |
|
| range | |
| Lower |
| range |
|
|
| |
Leg | range |
|
|
|
|
| |
leveler |
|
| |
| Raise |
|
|
| range |
|
|
| (on some models) | (on some models) | |
B | Check for levelness by placing a spirit |
| level or a cup, partially filled with water, |
| on one of the oven racks. If using a spirit |
| level, take two |
| placed diagonally first in one direction |
| and then the other. |
C | Remove the broiler drawer or kick panel. |
| See the Care and cleaning of the range |
| section. The front leveling legs can be |
| adjusted from the bottom and the rear |
| legs can be adjusted from the top or the |
| bottom. |
D Use an | |
| to adjust the leveling legs until the range |
| is level. |
7INSTALLTHE ANTI-TIP DEVICE
WARNING —
•Range must be secured with an approved
•Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.
•After installing the
•This range has been designed to meet all recognized industry tip standards for all normal conditions.
•The use of this device does not preclude tipping of the range when not properly installed.
•If the
AMark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.
E After the range is level, slide the range |
away from the wall so that the |
device can be installed. |
Slotted head screw
device
Wallplate 
Approx. 20°
21⁄8″ | Marked edge |
of range |
BLocate the outside edge of the device
21⁄8 ″ toward the center of the range from the marked edge of the range.
CUsing the device as a template, mark the position of the hole for the screw.
38
