HOW TO Prepare The Carpet Shampooer/ Extractor For Carpet Cleaning
IMPORTANT: For best results, begin with a clean surface by vacuuming surface or item before using the carpet shampooer/extractor.
NOTE: FAMILIARIze yourself with the parts of the carpet shampooer/extractor by reading this owner’s manual before using.
NOTE: Mix cleaning solution properly to avoid damage to carpet and upholstery.
Carrying
HandleLift
Latch
A. Fill the Clean Water Solution Tank
1)Lift up the tank latch to release the clean water solution tank.
2)Grasp the carrying handle on the clean water solution tank and remove it from unit.
3)Remove cap and add 4 ounces of Genuine GE carpet/upholstery shampoo to the tank.
4)Fill tank to the designated fill line with warm tap water, not to exceed 120°F, replace cap (see diagram).
5)Place clean water solution tank into the carpet shampooer/ extractor unit by
a)place the bottom of tank into the reservoir.
b)gently push upper portion of tank into unit until it snaps securely into place.
Tank Latch
l
l
4)
l
Fill Line - 1 Gallon
NOTE: When moving the carpet shampooer/extractor from one location to another, always make sure the recovery and clean water solution tanks are completely empty. Then tilt the unit slightly backward and roll on rear wheels or use the carpet shampooer/extractor’s carrying handle for transporting up and down stairs.
8
