GE AG_07 Controls, Operating Instructions Safety Instructions, Consumer Support, Remote Control

Operating Instructions Safety Instructions

About the controls on the air conditioner–models with touch pads.

Features and appearance will vary.

Air Conditioner Controls Remote Control

Controls

Troubleshooting Tips Installation Instructions

ON/OFF Pad

Turns air conditioner on and off.

Display

Shows the set temperature or time remaining on timer.

MODE

Use to set the air conditioner to COOL or FAN mode.

Increase ▲ /Decrease ▼ Pads

Use to set temperature when in COOL mode.

FAN Pad

Use to set the fan speed to LOW (F1), MED (F2) or HIGH (F3).

ENERGY SAVER–Controls the fan.

ON–The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. Note: The fan will continue to run for a short time after the compressor cycles off.

OFF–The fan runs all the time, while the compressor cycles on and off.

This switch must be set at OFF in order to use the fan settings (on the mode control).

CIRCULAIRE

For continuous side-to-side air circulation (cool settings only), set the Circulaire switch to ON.

For fixed side-to-side air direction, turn ON until the desired air direction is obtained, then turn it OFF.

TIMER Pad

ON–When the air conditioner is off, it can be set to automatically come on in 1 to 12 hours at its previous setting. Each touch will set the timer in hours.

OFF–When the air conditioner is on, it can be set to automatically turn off in 1 to 12 hours. Each touch will set the timer in hours. After the timer has been on for 30 minutes, the temperature will automatically rise 2°F, and after another 30 minutes, it will automatically rise 2°F again. The temperature will then stay the same until the timer goes OFF.

To cancel the timer, press the TIMER pad until the display time disappears.

Remote Control Signal Receiver

Consumer Support

Remote Control

■ To ensure proper operation, aim the	■ Make sure nothing is between the air
remote control at the signal receiver	conditioner and the remote control
on the air conditioner.	that could block the signal.
■ The remote control signal has a range of up	■ Make sure batteries are fresh and installed
to 21 feet.	correctly–see the Care and Cleaning section.

4