GE AG_07 Safety, Instructions Troubleshooting, Tips Consumer Support, Vent Control

www.GEAppliances.com

Additional controls and important information.

Safety

Energy Saver (on some models)

The energy saver switch controls the fan.

ON —The fan and compressor cycle on and off together. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied.

OFF — The fan runs all the time, while the compressor cycles on and off.

This switch must be set at OFF in order to use the fan settings (on the mode control).

Instructions Operating

Vent Control

The vent control is located above the control knobs.

When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.

To open the vent, pull the lever toward you.

To close it, push it in.

Instructions Installation

Air Direction – Side-to-Side

On some models, the side-to-side air direction is adjusted by moving the lever to the left or right.

CIRCULAIRE (on some models)

For fixed side-to-side air direction, set the Circulaire switch to ON until the desired air direction is obtained, then move it to OFF.

For continuous side-to-side air circulation (cool settings only), set the Circulaire switch to ON.

Instructions Troubleshooting

Air Direction – Up and Down

Fingertip pressure on the horizontal louvers adjusts	(on some models)
the air direction up or down.

7

Tips Consumer Support