ge.com
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Safety
Cool Mode
Use the Cool mode with HIGH (F3), MED (F2) or LOW (F1) fan for cooling. Use the INCREASE ▲ / DECREASE ▼ pads to set the desired temperature between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it will take approximately 3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal
For Maximum
For Quieter & Nighttime
NOTE: If you switch from a Cool setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a Cool setting.
Instructions Operating Instructions
Fan Speed Mode
Use the fan at HIGH (F3), MED (F2) or LOW (F1) to | Since fan only settings do not provide cooling, |
provide air circulation and filtering without cooling. | a temperature setting will not be displayed. |
Power Outage Recovery Feature
In the case of a power outage or interruption, the | feature was set, it will resume its countdown. |
unit will automatically | You may need to set a new time if desired. |
used after the power is restored. If the Timer |
|
Installation Instructions
Vent Control
The vent control is located above the control panels.
When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.
To open the vent, pull the lever toward you. To close it, push it in.
Troubleshooting
Air
The
Air
Fingertip pressure on the horizontal louvers adjusts the air direction up or down.
5
