GE AHG20 Safety Instructions, Operating Instructions, Customer Service, Troubleshooting Tips

Removing Collected Water

There are 2 ways to remove collected water:

Use the bucket. When the bucket is full, the WATER FULL indicator blinks and the unit beeps 3 times and stops. Wait a few minutes before removing the bucket to allow the water to stop dripping.

To remove: Tilt the bucket forward then lift carefully. After emptying, clean and replace it.

Use a hose. Water can be automatically emptied into a drain by attaching a length of thin-wall rubber or plastic tubing with an inside diameter of 1/2 inch. Use a screwdriver to remove the knockout at the back. Attach the tubing to the connector through the hole. The tubing should lead to the drain with no sharp bends.

Safety Instructions

Bucket

Cleaning the Grille and Case

Turn the dehumidifier off and remove the plug	Use water and a mild detergent to clean the inlet
from the wall outlet before cleaning.	and outlet grilles. Do not use bleach or abrasives.

Air filter

Operating Instructions

NOTE: The charcoal filter has been packed separately, in the bucket, in the front of the unit. Remove the wrap and insert it in the filter frame with the darker surface up.

The air filter is on the back of the dehumidifier. It should be checked and cleaned at least every 2 to 3 weeks or more often if necessary.

To remove: Turn the dehumidifier off and lift out the filter on the back of the unit.

Vacuum the nylon filter or wash with water. Make sure it is dry before replacing it.

The charcoal filter should be replaced every 3 to 6 months or when the inside surface has changed from white to a dark color.

Call 800-626-2002 to order a replacement.

Troubleshooting Tips

Nylon filter

Charcoal filter

5

Customer Service