Installation Instructions

Air Conditioner

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.

‡IMPORTANT ³6DYHWKHVHLQVWUXFWLRQV for local inspector’s use.

‡IMPORTANT ³2EVHUYHDOOJRYHUQLQJ codes and ordinances.

‡ Note to Installer – Be sure to leave these instructions with the Consumer.

‡ Note to Consumer – Keep these instructions for future reference.

‡ Skill level – Installation of this appliance requires basic mechanical skills.

‡ Completion time – Approximately 1 hour

‡ :HUHFRPPHQGWKDWWZRSHRSOHLQVWDOO this product.

‡ 3URSHULQVWDOODWLRQLVWKHUHVSRQVLELOLW\ of the installer.

‡ 3URGXFW IDLOXUHGXHWRLPSURSHULQVWDOODWLRQLVQRW covered under the Warranty.

‡ <RX0867XVHDOOVXSSOLHGSDUWVDQGXVHSURSHU installation procedures as described in these instructions when installing this air conditioner.

ELECTRICAL REQUIREMENTS

Some models require a 115/120-volt AC, 60-Hz grounded outlet protected with a 15-amp time-delay fuse or circuit breaker.

The 3-prong grounding plug minimizes the possibility of electric shock hazard. If the wall outlet you plan to use is only a 2-prong outlet, it is your responsibility to have it replaced with a properly grounded 3-prong wall outlet.

Some models require 230/208-volt AC, protected with a time-delay fuse or circuit breaker. These models should be installed on their own single branch circuit for best performance and to prevent overloading house or apartment wiring circuits, which could cause a possible fire hazard from overheating wires.

CAUTION:

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

Do not change the plug on the power cord of this air conditioner.

Aluminum house wiring may present special

SUREOHPV³FRQVXOWDTXDOLILHGHOHFWULFLDQ

TOOLS YOU WILL NEED

 

Phillips head screwdriver

Drill with 1/8” bit

Flat-blade screwdriver

Adjustable Wrench

Pencil

Ruler or tape measure

Level

Scissors or knife

Power cord includes a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button while plugged into the outlet. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.

7

Page 6 Page 8
Page 7
Image 7
GE AHM18 operating instructions Before YOU Begin, Electrical Requirements, Read these instructions completely and carefully
Page 6 Page 8

AHM18 specifications

The GE AHM18 is a cutting-edge helicopter model developed by General Electric, designed to meet the sophisticated demands of modern aviation. This aircraft stands out for its exceptional performance, advanced technology, and remarkable versatility, making it an ideal choice for a variety of missions, including search and rescue, medical evacuation, and law enforcement.

One of the main features of the AHM18 is its powerful engine configuration. The helicopter is equipped with two high-performance turboshaft engines that provide impressive horsepower and allow for rapid acceleration and swift climbs. This dual-engine setup not only enhances safety through redundancy but also contributes to improved fuel efficiency, enabling longer flight durations and extended operational range.

In terms of technology, the AHM18 incorporates state-of-the-art avionics that enhance pilot situational awareness and streamline operational efficiency. The cockpit is designed with a full glass-panel layout, featuring advanced displays that provide real-time data on navigation, weather conditions, and aircraft performance. This futuristic cockpit design minimizes pilot workload and improves decision-making capabilities during complex missions.

The AHM18 also boasts innovative rotor blade technology that significantly enhances its aerodynamics and performance. The composite blades are designed for greater lift while reducing drag, leading to improved fuel efficiency and flight stability. Additionally, the helicopter features an advanced fly-by-wire control system that offers precise handling characteristics, allowing pilots to maneuver the aircraft with ease in both urban and rugged environments.

Another remarkable aspect of the GE AHM18 is its modular design, which facilitates easy maintenance and upgrades. This feature ensures that operators can keep the helicopter at peak performance throughout its lifecycle, adapting to evolving operational needs with minimal downtime.

The spacious cabin of the AHM18 is designed for maximum comfort, accommodating a versatile range of configurations for passengers and cargo. The helicopter can be outfitted with medical equipment for air ambulance missions or modified for tactical operations, showcasing its adaptability.

In conclusion, the GE AHM18 is a formidable helicopter that brings together powerful performance, cutting-edge technology, and versatile design. Its combination of advanced avionics, innovative rotor blade technology, and modularity makes it a top choice for operators seeking a reliable and efficient aircraft capable of handling diverse missions with ease.
Top Page Image Contents