Operating Instructions Safety Instructions
About the controls on the air
Features and appearance will vary.
Cool on | Fan on |
|
|
Timer on
Energy Saver on
Remote Control
Air Conditioner Controls
Troubleshooting Tips Installation Instructions
ON/OFF
Turns air conditioner on and off.
Display
Shows the set temperature, time remaining on timer or fan speed
MODE
Use to set the air conditioner to COOL or FAN mode.
Increase ▲ /Decrease ▼ Pads
Use to set temperature when in COOL mode.
FAN
Use to set the fan speed to LOW (1), MED (2) or HIGH (3).
TIMER
To cancel the timer, press the TIMER pad until the display time disappears.
ENERGY SAVER – Controls the fan.
ON – The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. NOTE: The fan will continue to run for a short time after the compressor cycles off.
OFF – The fan runs all the time, while the compressor cycles on and off.
This switch must be set at OFF in order to use the fan settings (on the mode control).
Remote Control Signal Receiver
Support
Power Outage Recovery Feature
In the case of a power outage or interruption, the | will reset to the original setting. You may need to |
unit will automatically | set a new time if desired. |
used after the power is restored. The TIMER feature |
|
Consumer
Remote Control
■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
■The remote control signal has a range of up to 21 feet.
4
■Make sure nothing is between the air conditioner and the remote control that could block the signal.
■Make sure batteries are fresh and installed
