Through the Wall Installation
The case may be installed through the wall in both existing and new construction.
Read completely, then followSafety
1 IMPORTANT
Through the wall installation is not appropriate if any of the side louvers in the case will be obstructed by the wall.
All side louvers in the case must project on the outdoor side of the wall.
The room side of the case must project into the room at least 13⁄4″ from the finished wall.
The case must be installed level from
ARemove the air conditioner from the case. For specific instruction, refer to the Window Installation Instructions.
BMake certain a wall receptacle is available close to the hole location or make arrangements to install a receptacle.
CPlace the case in the wall opening and secure with 12 1″ long #10 wood screws.
NOTE: Drill pilot holes, if necessary, for proper installation. If the frame is oversized, use shims to prevent case distortion.
Instructions Operating Instructions Installation
2 | Finish the Wall Opening | |
Caulk all four sides on the outdoor side of the case to prevent moisture from getting through to the | ||
interior wall. Use of flashing (drip rail) will further prevent water from dripping inside the wall and | ||
down the outside of the building. | ||
|
Instructions
Lintel angle (if required)
Caulking
OUTSIDEAir louvers (must project on the outdoor side of the wall.)
Wood Filler and Caulking
(above & below the flashing)
Flashing (Drip rail)
Plaster line
Trim molding (if desired)
INSIDEBottom rail
4.5 cm (13/4″) min.
Troubleshooting Tips Consumer Support
15