GE ASM14 Operating Instructions Safety Instructions, Support Troubleshooting Tips, Consumer

Operating Instructions Safety Instructions

About the controls on the air conditioner–models with touch pads.

Features and appearance will vary.

Low	Med	High	CIRCULAIRE	ENERGY
Fan	Fan	Fan	On	SAVER On
On	On	On

Cool

Mode On

Fan	Timer
Only	On
On

Air Conditioner Controls Remote Control

Installation Instructions

ON/OFF

Turns air conditioner on and off.

Display

MODE

Use to set the air conditioner to COOL or FAN.

Increase ▲ /Decrease ▼ Pads

Use to set temperature when in COOL mode.

FAN

Use to set the fan speed at LOW, MED or HIGH.

TIMER

ON–When the air conditioner is off, it can be set to automatically come on in 1 to 24 hours at its previous setting. Each touch will set the time in hours.

OFF–When the air conditioner is on, it can be set to automatically turn off in 1 to 24 hours. Each touch will set the time in hours.

To cancel the timer, press the TIMER pad until the display time disappears.

Support Troubleshooting Tips

CIRCULAIRE

Turn on to provide continuous side-to-side air circulation.

For fixed side-to-side air direction, turn ON until the desired air direction is obtained, then turn it OFF.

ENERGY SAVER–Controls the fan.

ON–The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied.

Note: The fan will continue to run for a short time after the compressor cycles off.

OFF–The fan runs all the time, while the compressor cycles on and off.

This switch must be set at OFF in order to use the fan settings (on the mode control).

SLEEP

Press to set the air conditioner to run for 8 hours before it automatically shuts off.

When the SLEEP pad is pressed, SLEEP scrolls across the display for approximately 15 seconds, then shows the time remaining.

One hour after the sleep timer is set, the set temperature will automatically increase 1°F.

To cancel the sleep mode, press the SLEEP pad a second time.

Note: The sleep timer will be cancelled if the TIMER, ENERGY SAVER or MODE pad is pressed.

Remote Control Signal Receiver

Consumer

Remote Control

■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

4■ The remote control signal has a range of up to 21 feet.

■Make sure nothing is between the air conditioner and the remote control that could block the signal.

■Make sure batteries are fresh and installed correctly–see the Care and Cleaning section.