5
Assemble and Attach the Sill and Support Brackets
Safety Instructions
ALoosely attach the sill brackets to the support brackets with 5/8″ long carriage bolts and nuts.
| Attach both sill brackets to the window sill |
C | |
| using two 1″ long screws on each side. |
|
Carriage bolt
Support bracket
Nut
D Tighten the bolts and nuts on both sides. |
Operating
Sill bracket
BFind the track hole that aligns with the sill bracket on the outer edge of the window sill. Using the 5/8″ long machine screws and nuts attach the support brackets to the case track hole on each side.
Level
NOTE: When finished, use a level to make sure the case tilts to the outside 1/4″ minimum. This prevents water from entering the room.
Instructions
6
Track hole
Sill
Measure and Cut the Window Filler Panels
| Measure the distance “X” between the face of |
| Using a sharp knife, mark the groove until |
A | C | ||
| the window molding and the side of the case. |
| the filler panel becomes weak enough to |
|
| ||
| Measure both sides of the case separately. |
| break apart. |
″X ″
Window molding
BSubtract 3/16″ (one groove) from “X” to determine the required width you need to cut the filler panels.
11
Installation Instructions Troubleshooting Tips
Customer Service