[EN] English - 5K386 Issue 1
Operation - Measure temperature
To measure temperature:
1. Connect the applicable thermocouples (Figure1/2) and, if
necessary, adjust the Set Up (Table1).
2. Select a Temperature input task from Select Task (Tab l e2)
and, if necessary, adjust the Settings (Table3).
If the display shows <<<< or >>>> :
• Make sure that the wires and the sensor are serviceable.
Figure 1: Example configurations - To measure the temperature
with one or two thermocouples
The examples in Figure1 show how to compare temperatures or
measure different temperatures in a system.
.
Figure 2: Example configuration - To measure the temperature
difference
Operation - IDOS Pressure measurements
UMM - Pressure options only. Read all the instructions supplied
with the UMM and then use the specified procedures to connect
it (Figure3/4).
Figure 3: Example configuration - Pressure measurement
with a UMM
Settings Settings
KK
a) T1 or T2 b) T1 and T2
T1
T2
T2
T1
Reference
T1 T2
T1 T2
Settings
a) T1 - T2
KKT2
T1
Settings
a) Pressure b) Leak test
Start Settings