Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
Special Installation Requirements:
Stacked Installation:
•Bracketsforstackingdryeroverwasherarenotincludedwiththewasher.
Order part no. GEFLStACK or part no. WE25X10018.
Alcove or Closet Installation:
•Ifyourdryerisapprovedforinstallationinanalcoveorcloset ,itwillbe
stated on a label on the dr yer back.
•ThedryerMUSTbeexhauste dtotheoutside.
•Minimumclearancesbetweendryercabinetandadjacentwallsorother
surfaces are: 0" either side, 3" front an d rear
•Minimumverticalspacefromflo ortooverheadcabinets,ceilings,etc. is52".
•Closetdoorsmustbelouveredorotherwiseventilatedand mustcontaina
minimum of 60 sq. in. of open area e qually distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in. of
open area equally distributed.
•Nootherfuel-burningapplianceshallbeinstalledinthesameclosetwith
a gas dryer.
Bathroom or Bedroom Installation:
•ThedryerMUSTbeexhauste dtotheoutdoors.
•Theinstallationmustconformwiththelocalcodes,orin theabsenceof
local codes, with the National Fuel Gas Code, ANSI Z223.
Minimum Clearance other than Alcove or Closet Installations:
•Minimumclearancestocombustiblesur faces0"bothsides,3"rear.
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
Stacked Dimensions (in inches)
27
13
28-3/4
Pedestal Dimensions (in inches)
SBSD137HWW - white
this optional 13" pedestal raises
the door opening and height of
the washer or dryer. Feet on 13"
pedestalallowittoadjustto
13-3/8" height.
Specification Revised 10/10 360478
GFW N1100 L
GE® ENErGy StAr® 4.0 IEC Cu. Ft. King-Size Capacity Frontload Washer with Stainless Steel Basket

80-1/8

Above illustrations intended for dimensional reference only.
refer to photography for actual product appearance.