Dishwasher Installation
STEP 20: DISHWASHER WET TEST
■
Turn on power supply or plug power cord into outlet, if equipped.
■
Latch door.
■
Push “Rinse Only” pad.
■
Push Start/Reset pad one time. Dishwasher should start.
■
Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on.
■
Check for leaks under the dishwasher. If a leak is found, turn off power at the breaker, and then tighten water connections. Restore power after leak is corrected.
■
Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinets. Reposition the dishwasher if necessary. See Step 15.
■
The dishwasher will drain and turn off about 5 minutes after it was started. Check drain lines. If leaks are found, turn off power at the breaker and correct plumbing as necessary. Restore power after corrections are made. See Steps 7 and 17.
■
Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged. Also check drain hose to be sure it is not kinked underneath or behind dishwasher. See Step 17.
■
Press Start/Reset pad once again and run dishwasher through another “Rinse Only” cycle. Check for leaks and correct if required.
STEP 21: REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
Attachment
Screws
Figure CC
•Align the toekick with the bottom edge and make sure it is against the floor.
•Insert and tighten the two toekick attachment screws. The toekick should stay in contact with the floor.
Tip: Reduce sound from under the dishwasher
Make sure toekick is against floor.
STEP 22: LITERATURE
•Be sure to leave complete literature package, these Installation Instructions and product samples and/or coupons with the consumer.
13
