Dishwasher Installation
CAUTION
Do not remove wood base until you are ready to install the dishwasher. The dishwasher will tip over when the door is opened if base is removed.
STEP 1: PREPARATION
Locate the items in the installation package and set aside for use in the listed steps:
•Screw kit – Steps 5 or 18 and 15
•Junction box cover – Step 5 or 18
•Drain hose and clamp – Step 7
•Drain hose hanger – Step 17
•Trim pieces (some models) – Step 11
•Owner's Manual - Steps 19 and 22
•Product Samples and/or coupons – Step 22
STEP 2: CHECK DOOR BALANCE
•With dishwasher on the wood base, check the door balance by opening and closing the door.
•Door is properly balanced if it gently drops from a 1/2 open position and does not rise from the full open position.
•If necessary increase or decrease tension
as shown. Latch door and adjust both springs to the same tension setting to correct balance.
STEP 3: REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT – Do not kick off wood base! Damage will occur.
•Move the dishwasher close to the installation location and lay it on its back.
•Remove the four leveling legs on the underside of the wood base with a 15/16" socket wrench.
•Discard base.
Approx.
1/8"
Figure H
•Screw leveling legs back into the dishwasher frame, approximately 1/8" from frame as shown.
| Insert Hook |
Increase | Over Bracket |
Spring |
|
Tension |
|
Decreas | Correct |
| |
Spring |
|
Tension |
|
| Incorrect |
Figure G
Tip: Make sure door opens and closes smoothly
Check door opening and closing. If door does not open easily or falls too quickly, check spring cable routing. The cable is held in place by “shoulders” on the pulley. Check to be sure cable has not slipped over the pulley shoulders.
STEP 4: REMOVE TOEKICK
•Remove the 2 toekick screws and toekick. Set aside for use in Step 21.
Remove 2
Toekick Screws
Figure I
6