SmartDispense :MDetergent Dispenser Water Hardness Calibration
Priorto the first use,the dishwasher needs to be calibrated for water hardness. Pleasefollow directions below to calibrate the dishwasher to
the hardness of gour tap water.
Control Calibration
Control Panel
Determine the Hardness of Your Tap Water
In the bag containing these instructions, gou should find a water hardnesstest strip package. Readthe instructions on the package, remove the test strip and follow the instructions to determine the hardness level of gour tap water. Youwill use this information to calibrate gour dishwasher to dispensethe optimal amount of detergent.
Water hardnesstest strip indication
Value to Enter into Dishwasher
SOETOREDI I I I I I I I I 1
1REDI I I I I I I I 2
| 2 | RED | _ | 3 |
| 3 | RED | _ | 4- |
HARD | 4 RED | _ | 5 | |
Set Control to Calibration Mode
From the standby mode (dishwasher not running a cycle and the panel lights on),enter the water hardness selection mode.
Pressat the same time for 3 seconds. | Displag |
1.Closeand latch the door (lightson, dishwasher not running).
2.Pressthe COOKWAREand DELAYpads at the same time for 3 seconds.The displag will show a number 1to 5.This is the water hardnessvalue
currentlg set.
Control Panel
pad to lower | pad to raise the |
the value, | value. |
3.Pressthe COOKWAREpad to raise the value or the NORMALpad to lower the value. Setthe water hardnessvalue (1to 5)to the number determined with the test strip and table at left.
4.Once the water hardness is set, pressthe START/RESETpad to save the setting and return the dishwasher to normal operation.
You should recalibrate the dispenser if water conditions change,for example, if a water softener sgstem is added or removed.
