GE GNSV70FBL owner manual Installing the Tubing, Installation Instructions, Incorrect

Installation Instructions.

Installing the Tubing

1.Measure 3/4″ from the end of each remaining piece of tubing (faucet end and inlet end) and mark with a pencil (Fig. 10). (Check for roundness, smoothness, cuts, nicks, flat spots and sharp edges.)

3/4″ (19 mm)

Fig. 10

INCORRECT

2.NOTE: Water flow is from left to right. Water inlet is on the left side and water outlet is on the right side. Failure to follow will result in water leaks when filter canisters are removed.

Inlet from supply valve	Outlet
	to faucet

3Push the tubing firmly into each fitting on the manifold until the line is flush with the fitting collar. (If the tubing is removed, re-cut the end, measure, mark and re-insert). Tubing must be fully inserted to avoid leaks (Fig. 11). (To remove tubing, depress and hold white collet; pull tubing out to remove.)

White Collet

(DO NOT REMOVE)

Insertion line 3 4"

Insert tubing

Engagement

″	″	tubing)	Fig. 11
3/4	(3/8

4Pull out slightly on tubing to ensure a good seal.

12