REFERENCE

Programming the Remote to Control a Cable Box

1.Turn on the cable box.

2.Look up your brand and its code number(s) in code list on page 55.

3.Press and hold the ALT button.

4.Press and release the DSS® button.

5.Enter the three-digit code from the code list.

6.Release the ALT button and press ON•OFF or CHAN UP or DOWN to see if the cable box responds to the remote commands.

7.Repeat these steps using the next code listed for your brand until the cable box responds to the remote commands.

Programming the remote to control a laserdisc player

1.Turn on the laserdisc player.

2.Look up your brand and its code number(s) on code list on page 55.

3.Press and hold the ALT button.

4.Press and release the VCR button.

5.Enter the three-digit code from the code list.

6.Release the ALT button and press ON•OFF or another button to see if the laserdisc player responds to the remote commands.

7.Repeat these steps using the next code listed for your brand, until the laserdisc player responds to the remote commands.

Using the Remote Buttons to Control a Device

Once the remote has been programmed with the correct codes, you are ready to use it to control your devices.

To operate the device:

1.Press the device button (TV, DSS®, VCR, or ALT) to set the remote to control the device.

2.Press OFF•ON to turn the device off or on.

3.Use the remote buttons that apply to that device.

This remote may not operate all models of the brands that are shown. Use the codes shown in this manual, or on the sheet packed with your remote.

53

Page 55
Image 55
GE GRD33G3A manual Using the Remote Buttons to Control a Device, Programming the Remote to Control a Cable Box