GE GSD4030 Water standing, Bottom of the tub, Out of the tub, Water won’t pump, Suds in the tub

InformationSafety	Before you call for service…
	Troubleshooting Tips
	Problem	Possible Causes	What To Do
	Water standing in	This is normal	• A small amount of clean
Instructions	the bottom of the tub		water around the outlet on
	out of the tub		the tub bottom at the back
			clean it.
			of the tub keeps the water
			seal lubricated.
Operating	Water won’t pump	Drain is clogged	• If you have an air gap,
			• If the dishwasher drains
			• Check to see if your kitchen
			sink is draining well. If not,
			you may need a plumber.
			into a disposer, run
			disposer clear.
	Suds in the tub	Correct detergent	• Use only automatic
Tips		wasn’t used	dishwasher detergents to
			avoid sudsing.
Troubleshooting			• To remove suds from the
			Dial until a drain period
			tub, open the dishwasher
			and let suds evaporate.
			Add 1 gallon of cold water
			to the tub. Close and latch
			the dishwasher. Pump out
			water by slowly turning the
			is reached. Repeat if
			necessary.
		Rinse agent	• Always wipe up rinse agent
		was spilled	spills immediately.
Service	Steam	This is normal	• Steam comes through the
			water is being pumped out.
			vent by the door latch
			during drying and when
Customer
	20