GE GSD4112 Dishes and flatware, not clean, Use HI TEMP WASH, Safety Information, Customer Service

Problem	Possible Causes	What To Do
Dishes and flatware	Inlet water temperature	• Raise the water heater
not clean	is below 120°F	temperature to 120°F.
		• Use HI TEMP WASH.
	Water pressure is	• Turn on a faucet. Is water
	temporarily low	coming out more slowly
		than usual? If so, wait until
		pressure is normal before
		using your dishwasher.
	Air gap is clogged	• Clean the air gap.
	Improper rack loading	• Make sure large dishware
		does not block the
		detergent dispenser or the
		wash arm.

Safety Information

Operating Instructions

Spots and filming on glasses and flatware

Extremely hard water

Low inlet water temperature

Overloading the dishwasher

Improper loading

Old or damp powder detergent

Rinse agent dispenser empty

Too little detergent

•Use Jet-Dry®rinse agent to remove spots and prevent new film build-up.

•To remove stubborn spots and pre-existing film from glassware:

1Remove all metal utensils from the dishwasher.

2Do not add detergent.

3Select the POT SCRUBBER cycle and HEATED DRY option.

4Start the dishwasher and allow to run for 26 minutes. Dishwasher will nowbeinthemainwash.

5Open the door and pour 2 cups (500 ml) of white vinegar into the bottom of the dishwasher.

6Close the door and allow to complete the cycle.

If vinegar rinse doesn’t work: Repeat as above, except use 1/4 cup (60 ml) of citric acid crystals instead of vinegar.

Troubleshooting Tips

Customer Service

21