Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent spotting on dishware. This option may be turned ON or OFF during the wash cycle.
HI TEMP WASH Energizes the heater in all prewash fill cycles. Recommended for use with heavily soiled dishes. Option may be turned ON or OFF during the wash cycle.
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is OFF saved. You can prop the door open after the light goes ON below the word
CLEAN.
HEATED DRY Turns the heater on for fast drying. This option will extend the time to your ON wash cycle by 30 minutes. NOTE: This cannot be selected with RINSE &
HOLD cycle.
LOCK When the LOCK pad is touched twice within three seconds, all pads become inoperative. You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle or selected DELAY START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this option selected.
To unlock the pads after they have been locked, touch the LOCK pad twice within three seconds. The light above the LOCK pad will turn off.
DELAY START You can delay the start of a wash cycle for up to six hours (up to eight hours on some models). Press and hold the DELAY START pad to choose the number of hours you want to delay the start of the cycle. The machine will count down and start automatically at the correct time. NOTE: If you forget to latch the door, a reminder signal will beep until you do so.
Start
The light above the START/RESET pad will be ON to indicate that it has been selected.
Touch the START/RESET pad to begin the cycle. There is a time delay between
The cycle is complete when the light is ON below the word CLEAN.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and door latch is in the locked position, the control panel lights will be ON and will display the last settings you selected. If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY ON will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.
Reset
To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle. After water is pumped out and motor stops, you can reprogram and restart the dishwasher.
Safety Information
Operating Instructions
Troubleshooting Tips
Customer Service
9
