Safety Information
Operating Instructions
Troubleshooting Tips
Customer Service
About the control panel lights.
Display | What It Means | What To Do | |
|
|
| |
| Electrical power to the | IF DISHWASHER WAS IN USE WHEN | |
| dishwasher has been | THE POWER FAILURE OCCURRED: | |
| interrupted but is now | 1 Press the RESET pad and wait | |
RESET | back on. | ||
|
| approximately 30 seconds. | |
RESET |
| 2 Unlatch and open the door. | |
LIGHT |
| A If the detergent cup is open and | |
FLASHING |
| ||
| empty, close the door and rerun | ||
|
| ||
|
| the cycle with detergent in the | |
|
| closed cup only. | |
|
| B If the detergent cup is closed reset | |
|
| the dishwasher for the wash cycle | |
|
| you want. | |
|
| IF THE DISHWASHER WAS NOT IN USE | |
|
| when power failure occurred, use | |
|
| dishwasher as you normally would. | |
|
|
| |
DRY | There is too much water | The dishwasher is designed to | |
in the dishwasher. | automatically pump out extra water | ||
DRY | |||
| as long as the door is latched. When | ||
LIGHT |
| you hear the motor stop running: | |
FLASHING |
| 1 Unlatch the door and see if all the | |
|
| ||
|
| water is gone. (It is normal for a | |
|
| small amount of water to remain in | |
|
| the bottom of tub to keep the water | |
|
| seal lubricated.) | |
|
| 2 If you see water entering the | |
|
| dishwasher, close and latch the door. | |
|
| Shut off the water supply to the | |
|
| dishwasher. | |
|
| 3 Press the RESET pad. | |
|
| 4 If water is gone and no water is | |
|
| entering the dishwasher, restart | |
|
| cycle. | |
|
| 5 If the DRY light starts to flash again, | |
|
| shut off the water supply to the | |
|
| dishwasher. Call for service. |
10