GE GSD4210 Options, Start, Cycle Sequence, Safety Information, Operating Instructions, Cycles

	2	Options
		TEMP BOOST Provides extra heat for best performance. It is used
			best with heavily-soiled dishes.
		ENERGY	Shuts off the drying heat options. Dishes air dry
		SAVER	naturally and energy is saved. You can prop the door
		DRY ON	open after the word CLEAN appears in the display.
		ENERGY	Turns the drying heater on for fast drying. This
		SAVER	cycle will extend the time to your wash cycle.
		DRY OFF
		RESET	To change a cycle after washing starts, touch the
			RESET pad to cancel cycle. After water is pumped
			out and motor stops, you can reprogram and restart
			the dishwasher.
		DELAY START	You can delay the start of a wash cycle for up to 8
			hours. Tap or press and hold the DELAY START pad
			to choose the number of hours you want to delay
			the start of the cycle. The machine will count down
			and start automatically at the correct time. NOTE:
			If you forget to latch the door a reminder signal will
	3		beep until you do so.
		Start
		Touch the START pad to begin the cycle. There is a time
		delay between start-up and water fill so you will not hear
		any wash action right away.
Cycle Sequence
	Water	Time
Cycles	(approx.)	(approx.)	Cycle Sequence
NORMAL WASH	8.4 gal.	63 min.	Rinse Rinse Main Wash Rinse Rinse Rinse
POTS PANS	9.9 gal.	63 min.	Rinse Rinse Rinse Main Wash Rinse Rinse Rinse
SHORT WASH	6.9 gal.	63 min.	Rinse Rinse Rinse Main Wash Rinse Rinse Rinse
CHINA CRYSTAL	7.7 gal.	63 min.	Rinse Rinse Main Wash Rinse Rinse Rinse

Drying Options:

ENERGY SAVER DRY OFF. Available on all wash cycles. Add approximately 32 minutes to the cycle.

ENERGY SAVER DRY ON. Drying heater is turned off.

Dishes dry naturally.

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

9