165D6290G029
MODELS WITHOUT A TURBIDITY SENSOR
THIS DISHWASHER IS PROGRAMMED WITH A SERVICE MODE TO AID THE TECHNICIAN IN TROUBLESHOOTING THE DISHWASHER. EACH COMPONENT MAY BE CYCLED TO DETECT IF IT IS FUNCTIONING CORRECTLY. COMPONENTS ARE CYCLED BY PRESSING KEYPADS TO THE LEFT OF THE START/RESET KEYPAD. USE THE MATRIX BELOW TO DETERMINE HOW TO CYCLE EACH COMPONENT.
10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 |
NOTE: INDICATES KEYPAD USED ONLY ON SOME MODELS. WHILE THIS KEYPAD MAY
NOT BE VISIBLE, THE INDICATED SPACE SHOULD ALWAYS BE USED AS A KEYPAD.
TO ENTER SERVICE MODE : |
| TO EXIT SERVICE MODE : |
PRESS KEYPAD #9 AND KEYPAD #1 SIMULTANEOUSLY FOR |
| PRESS THE START/RESET KEYPAD AT ANYTIME TO EXIT. |
5 SECONDS. |
|
|
|
|
|
Service Mode Test Matrix*
Keypad | Description | Time in Seconds** | |
10 | Activates Main Pump | 120 | |
9 | Activates Auxiliary Pump | 60 | |
Activates Drain Solenoid | 6 | ||
| |||
8 | Activates Detergent Module | 30 | |
7 | Activates Water Valve | 60 | |
6 | Activates Heating Element | 120 | |
START/RESET | Used to EXIT Service Mode |
|
*NOTE: After 5 minutes of inactivity, the service mode will automatically turn off.
**NOTE: When a component is activated in the SERVICE MODE, the output will continue to remain active (ON) until the Maximum time has expired or another keypad is pressed.
N.D.
