About the dishwasher control panel.
Safety Instructions
4 Start
Close the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad to begin the cycle. Water fill begins, and approximately 60 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher door is fully closed, the control panel lights will display the last settings you selected.
If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
If the door is closed the indicator lights will turn off if the START/RESET pad is not selected within two minutes. To activate the display, open and close the door or press any pad.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.
Operating Instructions
Troubleshooting Tips
5 Clean
The CLEAN light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.
Flashing display lights.
Status Indicator Lights | What It Means |
START/RESET | Cycle has been interrupted by pressing the START/RESET pad. Light will quit |
| flashing after the dishwasher automatically drains out the water. |
Using the dishwasher.
Check the Water Temperature
The entering water should be at least 120°F and not | faucet nearest the dishwasher, place the thermometer |
more than 150°F, for effective cleaning and to prevent | in a glass and let the water run continuously into the |
dish damage. Check the water temperature with a | glass until the temperature stops rising. |
candy or meat thermometer. Turn on the hot water |
|
Use Jet-Dry ® or Cascade Rinse Aid® Rinse Agent
Support
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill.
| Make sure the dishwasher door is fully open. |
1 | |
| Turn the dispenser knob to the left and lift it out. |
2 | |
| Add rinse agent until the indicator window looks full. |
3 | |
| Clean up any spilled rinse agent with a damp cloth. |
4 | |
| Replace the dispenser knob. |
5 |
Indicator |
|
window | Dispenser cap |
Consumer
| Rinse Aid Setting |
| The amount of rinse agent released into the final wash can be |
| adjusted. The factory setting is at the midpoint. If there are rings |
| of calcium (hard water) spots on dishes, try a higher setting. |
| To adjust the setting |
6 | Remove the dispenser knob, then turn the adjuster counterclockwise |
to increase the amount of rinse agent. |
Rinse agent adjuster
