www.GEAppliances.com
SPEED CYCLE | Heavy 7.8 gal., 37 min. |
or | Medium 6.5 gal., 33 min. |
SPEED WASH | Light 5.2 gal., 29 min. |
(on some models) |
|
| This cycle is for everyday dishes and glassware. |
|
|
CHINA CRYSTAL Heavy 9.1 gal., 52 min. (on some models) Medium 7.8 gal., 45 min.
Light 6.5 gal., 38 min.
This cycle is for lightly soiled china and crystal.
RINSE ONLY Heavy 2.6 gal., 7 min.
Light 1.3 gal., 4 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE: This dishwasher is equipped with an ExtraClean™ Sensor with automatic temperature control; therefore cycle length and time may vary depending on soil and temperature conditions.
NOTE: Only the
3 |
| Extras |
|
|
| The light above the selected pad will be ON to indicate which EXTRA has been selected. | |
|
| ||
|
| EXTRA | For use with heavily soiled and/or |
|
| SCRUB | PRIOR to starting the cycle. This option adds 16 minutes to the cycle time. |
|
| (on some models) | NOTE: Cannot be selected with RINSE ONLY cycle. |
|
|
|
|
|
| HEATED DRY | Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For faster air dry, |
|
| Light OFF | you can prop the door open after the CLEAN light illuminates. |
|
|
|
|
|
| HEATED DRY | Turns the heater on for fast drying. This will extend the time to your wash cycle by 8 minutes |
|
| Light ON for the SPEED CYCLE and 30 minutes for all other cycles. NOTE: Cannot be selected with | |
|
|
| RINSE ONLY cycle. |
|
|
|
|
|
| LOCK | You can lock the controls to prevent any selections from being made. Or you can lock the |
|
|
| controls after you have started a cycle. |
|
|
| Children cannot accidentally start dishwasher by touching pads with this option |
|
|
| selected. |
|
|
| To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds. |
|
|
| To lock the dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light above |
|
|
| the LOCK pad will turn off. |
|
|
|
|
|
| EXTRA | When selected, the cycle will run longer with heating elements on to improve both wash and |
|
| HOT WASH | dry performance. NOTE: Cannot be selected with RINSE ONLY cycle. |
|
|
| |
|
| DELAY HOURS You can delay the start of a wash cycle for up to 8 hours. Press the DELAY HOURS pad to | |
|
|
| choose the number of hours you want to delay the start of the cycle, then press START/RESET. |
|
|
| The machine will count down and start automatically at the correct time. Pressing START/RESET |
|
|
| a second time will cancel the DELAY START selection. NOTE: If you forget to fully close the |
|
|
| door, a reminder signal will beep until you do so. |
|
|
|
|
|
| RESET | To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle. |
|
|
| The START/RESET light will flash while the water is pumped out if needed. This takes |
approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed and restarted.
5
Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
