Installation Instructions
TRANSFER BOTTOM HINGE
TO THE LEFT
To access the bottom hinge, move the refrigerator
so it is 30″from a wall. Then carefully tip the
refrigerator back until it rests against the wall.
CAUTION:Be sure that the coils
on the back of the refrigerator do not rest against
the wall. Doing so could damage the coils.
Remove the screws (some models have washers
with each screw), leveling leg and bottom hinge from
the right side. Remove the leveling leg from the left side
of the cabinet and install it in the right side.
Reassemble the bottom hinge on the left side.
NOTE: The leveling legs are not interchangeable.
4
11
30″
TRANSFER FRESH FOOD DOOR STOP
TO THE LEFT
Remove the door stop from the bottom of the right
side of the door. Transfer the plug buttons from
the bottom left side to the right side.
Install the door stop on the left side.
5
REHANG THE FRESH FOOD DOOR
Make sure the washer(s) are in place on the bottom
hinge pin. Place the fresh food door on the bottom
hinge, close the door and tape it in place with
masking tape.
Remove the plug button from the left edge of the door
and insert it into the hole on the opposite side.
6
INSTALL CENTER HINGE
ON THE LEFT
Remove the three plug buttons on the left side
and install them on the right.
Install the center hinge designed for the left side
that came with the refrigerator, with the screws, spacer
and washer(s) (on some models) that you removed
in Step 2.
Remove the tape holding the door shut.
CAUTION:When assembled correctly,
the hinge is tight against the cabinet.
ATTENTION: The screws must be properly tightened.
Turn the screws until snug. Then tighten the screws
a minimum of 1/2 turn using both hands.
7
Plug button