GE JBP35SMSS and Cleaning, Troubleshooting Tips Consumer Support, To Stop a Clean Cycle, Safety

ge.com

How to Delay the Start of Cleaning (on some models)

Safety

Self

Clean

Start Time

Start

On

Make sure the clock shows the correct time of day.

Latch the door.

Touch the Self Clean pad.

Using the + or – pads, enter the desired clean time.

Touch the Start Time pad. The earliest start time you can set will appear in the display.

Using the + or – pads, enter the time of day you want the self-cleaning cycle to start.

Touch the Start/On pad.

The display will show the start time. It will not be possible to unlatch the oven door until the temperature drops below the lock temperature.

The oven shuts off automatically when the self-cleaning cycle is complete, and 0:00 will flash in the display.

Instructions Operating Instructions Care

To Stop a Clean Cycle

Touch the Clear/Off pad.

Wait until the oven has cooled below the locking temperature to unlatch the door. You will not be able to open the door right away unless the oven has cooled below the locking temperature.

and Cleaning

After a Clean Cycle

You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap-filled scouring pad and rinse thoroughly with a vinegar and water mixture.

These deposits are usually a salt residue that cannot be removed by the self-cleaning cycle.

If the oven is not clean after one self-cleaning cycle, repeat the cycle.

■You cannot set the oven for cooking until the oven is cool enough for the door to be unlatched.

■While the oven is self-cleaning, you can touch the Clock pad to display the time of day. To return to the clean countdown, touch the Cooking Time pad.

■Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven shelves with the paper towel. Do not spray with Pam® or other lubricant sprays.

Troubleshooting Tips Consumer Support

17