ge.com
Oven Shelves
Safety
All oven shelves may be cleaned by hand with an abrasive cleaner or steel wool. After cleaning, rinse the shelves with clean water and dry with a clean cloth. Gray
It will be necessary to grease all oven shelf side edges with a light coating of vegetable oil after cleaning them by hand or in the oven. This will help maintain the ease of sliding the shelves in and out of the oven.
Instructions Operating
Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse
or circuit breaker panel.
Be sure to let the light cover and bulb cool completely.
To remove the cover:
Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a
To replace the cover:
Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place.
Connect electrical power to the range.
Instructions Care and Cleaning
Storage Drawer Removal
To remove the drawer: | To replace the drawer: |
Rail | Stop guide |
Pull the drawer out until it stops.
Lift the front of the drawer until the stops clear the guides.
Remove the drawer.
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push back until the stops clear the guides.
Lower the front of the drawer and push back until it closes.
Painted Surfaces
Painted surfaces include the sides, top | Do not use commercial oven cleaners, |
of backguard and the drawer front. | cleaning powders, steel wool or harsh |
Clean these with soap and water or | abrasives on any painted surface. |
| |
a vinegar and water solution. |
|
21
Troubleshooting Tips Consumer Support
