1
31-10595-2 1-07 JR

BEFORE YOU BEGIN

Read these instructions carefully and
completely.
IMPORTANT — Save these
instructions for local inspector’s use.
IMPORTANT — Observe all
governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the consumer.
Note to Consumer – Keep these instructions
for future reference.
Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under the warranty.
NOTE – This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric drop-in ranges must be hard wired
(direct wired) into an approved junction box.
A plug and receptacle is NOT permitted on
these products
.

Electric

Drop-In Range

Installation
Instructions JDS28, JDP39

MATERIALS NEEDED

Junction Box Wire NutsStrain Relief Clamp
for 1/2” conduit

PARTS INCLUDED

Lower Trim
2 Screws
2 Shoulder Screws
(for stop device)

TOOLS YOU WILL NEED

1/8” Drill Bit and
Electric or Hand Drill
Phillips Screwdriver
Nut Driver
Level
Tape Measure
Straight Edge
or Square
Hand or Sabre Saw
Standard Screwdriver
Pencil
Safety Glasses
Hammer
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com