Using the clock and timer.

www.GEAppliances.com

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Press the CLOCK pad.

Press the number pads.

Press the START pad.

Instructions

The timer is a minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To Set the Timer

Press the KITCHEN TIMER ON/OFF pad.

Press the number pads until the amount of time you want shows in the display. For example, to set 2 hours and 45 minutes, press 2, 4 and 5 in that order.

If you make a mistake press the KITCHEN TIMER ON/OFF pad and begin again.

Press the START pad.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.

The 6 second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Operating Instructions Care and

To Reset the Timer

If the display is still showing the time

If the remaining time is not in the display

remaining, you may change it by pressing

(clock, delay start or cooking time are in

the KITCHEN TIMER ON/OFF pad, then

the display), recall the remaining time by

press the number pads until the time you

pressing the KITCHEN TIMER ON/OFF pad

want appears in the display.

and then pressing the number pads to

 

enter the new time you want.

To Cancel the Timer

Press the KITCHEN TIMER ON/OFF pad twice.

13

Cleaning Troubleshooting Tips Consumer Support

Page 13
Image 13
GE JDP46WDWW owner manual Using the clock and timer, Cleaning Troubleshooting Tips Consumer Support